Philips HD5730 Mode D'emploi page 21

4222.002.6507.7.indd 21
All manuals and user guides at all-guides.com
4 When you descale the appliance for the first time, use the descaler
supplied with the appliance. Fill the water tank with the descaler and
1 litre of water.
If you use a different descaler, follow the instructions on the package of the
descaler.
Note: Use the descaler supplied with the appliance or a liquid descaler based
on citric acid. Never use a descaler with acetic acid, as this will damage the
appliance.
Note: Be careful not to spill descaler on the metal surfaces of the machine
and on surfaces sensitive to acid such as marble, limestone and glaze. If you
spill descaler on these surfaces, immediately wipe it off with a cloth to prevent
stains.
5 Attach the hot water spout to the nozzle.
6 Place a bowl with a minimum capacity of 1.5 litres under the hot
water spout.
7 Press the OK button to start the descaling program.
Descaler comes out of the hot water spout and flows into the bowl
,
below. The message 'DESCALING' is shown on the display.
During the descaling program, the appliance pauses a few times to
,
remove scale deposits from the inside of the espresso maker.
After about 35 minutes, the message 'DESCALE DONE - Push OK
,
when ready' appears on the display.
You now have to flush the appliance to remove descaler residues from the
inside of the appliance. Proceed as follows:
8 Empty the water tank, rinse it and fill it with fresh water.
9 Reinsert the water tank.
10 Empty the full bowl and then put it back under the hot water spout.
11 Press the OK button.
Hot water comes out of the spout and flows into the bowl below.
,
The message 'FLUSHING...' is shown on the display.
The message 'FLUSHING - Push OK when ready' appears on the
,
display.
When the water tank is empty, the message 'FLUSHING DONE'
,
appears on the display.
The descaling program is now finished and the appliance is ready to brew
coffee again.
Note: If the descaling program is interrupted before completion, the appliance
continues to display the message 'PLEASE DESCALE!' and you have to start the
program from the beginning again.
setting coffee temperature
1 Press the MENU button.
The button lights up.
,
EnglisH
21
31-08-09 17:45