Uebler 15820 Notice De Montage Et D'utilisation page 16

Adjusting the lamps
B
4
If the vehicle or the load of the bicycle rack protrude at the
side more than 40 cm over the outer edge of the tail lights (9)
(distance B), move the tail lights (9) outwards.
7
1. Squeeze the locking mechanism (27), move the tail lights (7)
to the outer position and release the locking mechanism (27).
2. Check that the tail lights (7) sit firmly.
3. Prior to collapsing the bicycle rack (1), return the tail lights (7)
to the starting position in the reverse order.
4. without wing mirror
B
M+P-25A-0105
27
M+P-25A-0184
- 14 -
Preparations before driving
Attention
All screw connections and attachments of the bicycle rack and
the bicycles must be checked before assembly, before every
trip and during lengthy trips to ensure they are sitting firmly,
and they must be retightened if necessary.
The lighting system must be checked to ensure it is working
properly before every trip.
If these instructions are not followed, the bicycle rack together
with the mounted bicycles may free themselves from the
vehicle and cause injury to you and other persons, and/or may
result in an accident.
This check must be repeated at regular intervals regardless
of road conditions.
Attention
The bicycle rack license plate and the lighting system must
not be covered.
If the bicycle rack is not fully loaded, it must be ensured that:
• Brackets that are not in use are screwed closed and locked.
• All keys are removed and stowed away.
• The bracket for the third bicycle is stowed away.
• The lashing straps of all wheel rails are closed.
Replacing bulbs
Attention
When replacing bulbs the vehicle ignition must be switched
off and the plug for the lighting system removed from the trailer
hitch electrical system. Failure to do so can result in a short
circuit or damage to property. If you are not sure, the bulbs
should be replaced by a specialist dealer.
30
1. Undo the screws (30) and remove the lens (31).
31
30
M+P-25A-0127