Uebler 15820 Notice De Montage Et D'utilisation page 14

7. Remove plug (12) from the holder on the bicycle rack (1), plug
into the socket (20) of the trailer coupling's electrical system,
and turn clockwise as far as it will go.
8. Check the lighting system is working.
Removing the bicycle rack from the vehicle
The bicycle rack (1) is removed from the vehicle in reverse order.
Mounting/removing bicycles
Attention
The bicycle rack for the trailer hitch is only intended for
transporting bicycles.
Only bicycles, each with a max. weight of 30 kg, may be
transported on the bicycle rack.
The maximum allowable load capacity of the bicycle rack,
the tow bar load of the trailer hitch, the allowable total
vehicle weight and the maximum allowable vehicle axle
load (see vehicle owner's manual) must not be exceeded.
If these instructions are not followed, the bicycle rack together
with the mounted bicycles may free themselves from the
vehicle and cause injury to you and other persons, and/or may
result in an accident.
Attention
The bicycles must be mounted evenly and with a low centre
of gravity on the bicycle rack. Each must be secured against
falling off using a bracket on the bicycle frame and lashing
straps on front and rear wheels.
If this is not adhered to, bicycles and/or the loose parts could
free themselves from the vehicle and lead to an accident and
associated injury and property damage other road users.
Before mounting, remove child seats and all loose parts,
such a s water bottles, saddlebags, batteries from E bikes etc.,
from the bicycles and stow them.
Attention
A risk of injury exists if bicycles slip or tilt. Secure the bicycles
against slipping off/tilting.
Mount and dismount the bicycles together with another person.
20
12
M+P-25A-0180
Arrangement of the bicycles
1
Please note arrangement of the bicycles in the direction of travel
(arrow) as presented here.
Attention
Mount heavy bicycles close to the vehicle and light bicycles
(e.g. children's bikes) further out on the bicycle rack.
Mount the first bicycle with the toothed gear wheel facing
the vehicle.
Mounting the first bicycle
24
23
21
22
1. Press the latch (21) and pull out the lashing straps (22).
2. Unscrew the clamps (23) with the rotary handle (24) until the tube
diameter of the bicycle frame is reached.
3. Place the bicycle on the wheel rails (6) closest to the boot and
secure against tilting.
Attention
Only attach the bracket (8) to the bicycle frame, as other parts
of the bicycle could be damaged. Do not pinch components
such as gear or brake cables.
Faulty clamps must be replaced immediately.
- 12 -
6
M+P-25A-0155
6
M+P-25A-0181