Uebler 15820 Notice De Montage Et D'utilisation page 15

24
3
23
26
22
25
4. Attach the bracket (8) at the bicycle frame. Tighten the
clamp (23) with t3e rotary handle (24) and lock with the key (3).
Pull out the key (4).
5. Pass the lashing strap (22) between two wheel spokes, thread
into the buckles (25) and tighten (arrow) with the tensioning
lever (26).
6. Retighten the lashing straps (22) using the tensioning
lever (26) (arrow).
Attention
Do not tighten the lashing straps (22) too firmly, otherwise the
lashing straps (22) and/or the tyres/rims could be damaged.
Tightening the lashing straps (22) places these under tension.
To loosen this tension, the catch (21) may need to be
pressed firmly.
Note
The threaded screws on the bracket must be cleaned and
greased at regular intervals to avoid the rotary handles getting
stuck.
Mounting the second bicycle
10
The second bicycle is mounted in the same manner as the first.
Note that the bicycles are mounted in opposite directions.
Only attach the bracket (10) to the bicycle frame, as other parts
of the bicycle could be damaged. Do not pinch components
such as gear or brake cables.
Faulty clamps must be replaced immediately.
8
The second bicycle is attached using the long bracket (10).
Mounting the third bicycle
M+P-25A-0182
The third bicycle is mounted in the same manner as the first.
Note that the bicycles are mounted in opposite directions.
Only attach the bracket (2) to the bicycle frame, as other parts
of the bicycle could be damaged. Do not pinch components
such as gear or brake cables.
Faulty clamps must be replaced immediately.
The third bicycle is attached to the second bicycle with the
additional bracket (2).
Removing bicycles
The bikes are removed in the reverse order.
M+P-25A-0163
- 13 -
Attention
2
Attention
3. Uebler F32 hitch rack for 3 bicycles
(Order no. 15830)
3
M+P-25A-0164