Publicité
Les langues disponibles
Les langues disponibles
You have purchased an air compressor unit consisting
of a one cylinder, single-stage air compressor pump
and air tank.
This air compressor requires no oil. Now you can
enjoy all the benefits of having an air compressor
without ever having to purchase, add or change oil.
Your air compressor can be used for operating paint
spray guns, air tools, blow guns, nailers/staplers, air
brushes, and inflator kits. An air pressure regulator is
required for most of the applications.
CFM: Cubic Feet per Minute.
SCFM: Standard Cubic Feet per Minute; a unit of
measure of air delivery.
PSI: Pounds per Square Inch; a unit of measure of
pressure.
ASME: American Society of Mechanical Engineers;
made, tested, inspected and registered to meet the
standards of the ASME.
Cut-In Pressure: While the motor is off, air tank
pressure drops as you continue to use your acces-
sory. When the tank pressure drops to a certain low
level and the pressure switch lever is in "Auto", the
motor will restart automatically. The low pressure at
which the motor automatically restarts is called "cut-in
pressure."
Model No.
Number of Cylinders
Bore
Stroke
Voltage - Single Phase
Minimum Branch Circuit Requirement
Fuse Type
Amperage at Maximum Pressure
Air Tank/Capacity
Approximate Cut-in Pressure
Approximate Cut-out Pressure
SCFM @ 40 psi
SCFM @ 90 psi
D20415
Rev. 0
2/17/00
All manuals and user guides at all-guides.com
GENERAL INFORMATION
An inline air filter which removes moisture and dirt
from
compressed air should be used where applicable.
An inline regulator can be used if a more precise
adjustment of air pressure is needed downstream.
GLOSSARY
Cut-Out Pressure: When you turn on your air com-
pressor and it begins to run, air pressure in the air
tank begins to build. It builds to a certain high pres-
sure before the motor automatically shuts off - protect-
ing your air tank from pressure higher than its capac-
ity. The high pressure at which the motor shuts off is
called "cut-out pressure."
CSA: Electrical products sold in Canada are required
to be certified to the applicable CSA standard (s).
Canadian Standards Association (CSA) is a standards
writing and safety testing organization. Products that
are CSA certified have been evaluated and tested and
found to meet or exceed the applicable CSA standard
(s) for safety and electrical performance.
SPECIFICATION CHART
6 — ENG
919.727260
2
2 3/8"
1.2"
240
15 amps
Time Delay
15.0
ASME/33 gal. (U.S.)
100
130
14.2
9.9
Publicité
