Decommissioning And Disposal - eder 1800 Mode D'emploi

Decommissioning and disposal

90 Capstan winch 1800, 1200, 400
When the spark plug has been replaced:
›
Set the choke lever to the "| |" position.
›
Start the motor by pulling on the starter handle.
The motor starts.
›
Once the motor has started, switch the choke lever to the "| |"
position.
›
Idle the motor to warm it up.
If the motor has already been running and is warm, you do not
i
require the choke function.
Decommissioning and disposal
If the machine is no longer operable and is ready for scrapping, you
must deactivate and disassemble it, i.e. you must bring the machine
into a condition whereby it can no longer be used for the purposes for
which it was designed.
›
During the scrapping process, note that the basic materials of the
machine may be reused in the recycling process.
The manufacturing company rejects all responsibility for any
i
personal injury or material damage that is caused by the reuse
of machine parts, where these are used for any purpose other
than the original material purpose.
Proceed as follows to deactivate the capstan winch:
›
Drain the petrol mixture from the tank and dispose of the petrol
mixture in an environmentally friendly manner.
›
Block all moving machine parts.
›
Disassemble all rubber parts from the machine and take these to a
designated collection point.
900012 Rev. 01 | 09.2017