Inspection; Cleaning The Capstan Winch; Lubricating Moving Parts - eder 1800 Mode D'emploi

900012 Rev. 01 | 09.2017
›
Clean air filter sponge and replace,
›
Clean pulling rope and replace,
›
Check spark plug and replace.

Inspection

Each time before use, it is necessary to check the capstan winch and its
parts for external damage.
›
Check the capstan winch for external damage each time before use.
If you identify cracks or material deformations with sharp edges:
›
Send the capstan winch to the dealer for inspection.
›
Each time before use, make sure that all screws are tightened.
If the screws are loose:
›
Tighten the loose screws with a suitable Allen key.

Cleaning the capstan winch

›
Clean the capstan winch with a dry cloth.
›
Do not use degreasing, corrosive or aggressive cleaning agents.
›
Clean the capstan winch of wood residues and other dirt.

Lubricating moving parts

Slipping of the pulling rope!
If the lubricant comes into contact with the pulling rope and/or
capstan drum, the pulling rope may slip during the pulling operation.
The maximum traction of the capstan winch is not guaranteed.
›
Make sure that the pulling rope and/or capstan drum do not
come into contact with lubricant.
It is important that all turning and sliding parts are correctly and
adequately lubricated to ensure the correct function of the capstan
winch and to make operation easier. The capstan winch transmission is
lifetime lubricated. It is possible that the capstan winch may lose a little
lubricant during the first hours of operation. The lubricant must first
distribute through the transmission.
ATTENTION
Capstan winch 1800, 1200, 400
Cleaning and maintenance
85