DeWalt DC900 Mode D'emploi page 29

1 Variable speed switch
2 Forward/reverse slider
3 Keyless chuck/auto spindle lock
4 Torque adjustment collar
5 Mode selector
6 Three-gear selector
7 Bit holder
8 Grip
9 Side handle
10 Battery pack
Charger
Your DE9000 charger charger accepts D
Li-Ion battery packs of 36 V at 2.2 Ah (DE9360).
10 Battery pack
11 Release button
12 Charger
13 Charging indicators (red)
Auto-spindle lock
The auto-spindle lock is engaged when the
transmission is stationary. The chuck sleeve can
easily be turned with one hand while the other
supports the unit.
Electrical safety
The electric motor has been designed for one
voltage only. Always check that the battery pack
voltage corresponds to the voltage on the rating
plate. Also make sure that the voltage of your
charger corresponds to that of your mains.
#
Your D WALT charger is double
E
insulated in accordance with EN 60335.
Mains plug replacement
(U.K. & Ireland only)
● Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
D WALT repair agent or a qualifi ed electrician.
E
● Disconnect the plug from the supply.
● Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
● Only fi t 13 Amperes BS1363A approved plugs
fi tted with the correctly rated fuse (1).
All manuals and user guides at all-guides.com
● The cable wire colours, or a letter, will be
● Before replacing the top cover of the mains plug
WALT
E
!
Using an extension cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size
is 1 mm
Assembly and adjustment
@
@
Fitting and removing the battery pack (fi g. A)
● To fi t the battery pack (10), line it up with the
● To remove the battery pack, push the release
marked at the connection points of most good
quality plugs. Attach the wires to their
respective points in the plug (see below). Brown
is for Live (L) (2) and Blue is for Neutral (N) (4).
ensure that the cable restraint (3) is holding the
outer sheath of the cable fi rmly and that the two
leads are correctly fi xed at the terminal screws.
Never use a light socket. Never connect
the live (L) or neutral (N) wires to the
earth pin marked E or
2 ; the maximum length is 30 m.
● Prior to assembly and adjustment,
always remove the battery pack.
● Always switch off the tool before
inserting or removing the battery pack.
Use only D WALT battery packs and
E
chargers.
receptacle on the tool. Slide the battery pack
into the receptacle and push until the battery
snaps into place.
button (11) while at the same time pulling the
battery pack out of the receptacle.
E N G L I S H
.
29