Télécharger Imprimer la page

Bebeconfort Stone Mode D'emploi page 52

Publicité

EN
All manuals and user guides at all-guides.com
A - Seat cover
B - Adjustable headrest
C - Newborn inlay - exclusively for use with
Stone from 40 to 60 cm
D - Removable shoulder pads
E - 5-point Harness
F - Harness buckle
G - Harness adjuster button
H - Harness adjuster strap
I - Recline handle
J - Rotation handle
K - Support leg indicator
L - Support leg
M - Support leg adjuster button
N - Support leg height adjustment rack
O - G-CELL
P - ISOFIX connectors
Q - ISOFIX connectors release button
R - Headrest adjustment handle
S - User manual storage compartment
SAFETY
• The Stone is intended for car use only.
• The Stone is developed for an intensive use of
approximately 12 years.
• Do not use any load bearing contact points
other than those described in the instructions
and marked in the child restraint.
The Stone car seat in the car:
• The car seat can be rotated 360° to help you
get your child in and out of the vehicle easily.
This also allows you to change the position of
the seat from rearward facing to forward facing.
I
I
52
Stone
Bébé Confort
• Before buying this product make sure the car
seat is compatible with the vehicle it is to be
used in.
• The car seat must be installed with ISOFIX and
support leg.
• The support leg must always be unfolded
completely, locked and placed in the most
forward position.
• When the child restraint is installed in the
maximum rearward facing position, it may not
fit in all approved vehicles. Please check that
all possible positions of the car seat (recline
positions and headrest adjustment) fit in your car.
Your child in the Stone car seat
• The newborn inlay included in your Stone seat
plays an integral part in the efficiency of the
restraint system for your child from 40 to 60 cm.
It can be removed and the cover taken off for
washing, but it is essential to place it back again
where it belongs and only use this official Bébé
Confort Stone newborn inlay. This newborn inlay
is exclusively for use with the Stone seat.
• Make sure you can fit no more than one finger
between the harnesses and your child (1cm).
If there is more space than 1 cm, tighten the
harness belt further.
• Make sure the headrest is adjusted to the
proper height.
WARNING:
• The car seat must always be locked in the
forward facing or rearward facing position when
travelling. Do NOT travel when the car seat is

Publicité

loading