Milwaukee 48-22-8590 Manuel De L'utilisateur page 6

Using the Cutting Notches
To use the cutting notches, place the material to be
cut over the notches. Ensure the station casters and
drawers are locked, hold down the material and cut.
Using the Caster Brakes
To lock the swivel casters,
step down on the levers
marked ON. Be sure to lock
all casters to prevent station
from rolling or swiveling. To
unlock casters, push down
on the levers marked OFF.
Moving the Station on an Incline or
Rough Surface
Take care that the station does not tip or become
unbalanced when moving it on an incline or rough
surface. Do not exceed an incline of 10 degrees.
Lock the station and secure all items before moving.
Rolling the Station
The station is only intended for rolling short distances.
Only roll the station using the handle. Do not push or
pull station by the frame or product may tip. Do not
modify the station in any way. Drilling holes or modi-
fying the station will lower the load capacity, which
can cause the station to collapse, resulting in injury.
Lock the station and secure all items before rolling.
Lifting the Station
The station is not intended to be lifted. However, if
you need to lift, empty the station and then place
straps or forks inside and next to casters. Do not lift
loaded stations. Never lift by the side handle. Be sure
all bystanders are moved away before lifting station.
Mounting Chargers
The station comes equipped with twelve pre-installed
charger mounting bosses. Four are located on the
right side of the top tray, four on the left side of the
bottom tray and another four on its right. The charger
mounts are suitable for holding MILWAUKEE M18™
& M12™ Multi Voltage chargers as well as M18™
chargers.
To mount a charger, install a screw (DD) into each
boss, then slide the charger's key-hole slots over the
screws. Slide the charger toward the floor to lock it
onto the screws.
NOTE: Four (DD) screws are included for the char-
ger mounts.
MAINTENANCE
To reduce the risk of injury, contact
WARNING
MILWAUKEE Corporate After Sales
Service Technical Support for ALL repairs and
replacement parts.
Maintaining the Station
Keep your station in good repair by adopting a regu-
lar maintenance program. Before use, examine the
general condition of your station. Check for loose
screws, misalignment, binding of wheels, broken
parts and any other condition that may affect its safe
operation. Do not use a damaged station.
Maintaining the Casters
Grease the casters annually using high quality bear-
ing grease.
6
Grease
Points
DD