Publicité
Les langues disponibles
Les langues disponibles
CLEANING, CHECKS AND STORAGE
1. Cleaning
Use only a less wet cloth for cleaning. Caution: Never use benzene, thinner or other aggressive cleaning agents for surface cleaning
as this damage caused. The device is only for private home use and for use suitable indoors. Keep the unit clean and moisture from
the device.
2. Storage
Remove the batteries from the computer while intending the unit for more than 4 weeks not to use. Choose a dry storage in-house and
put some spray oil at front & rear foot tube connection point and hand grip axle. Also to the thread of the mounting screws for handle
and seat tube. Cover the bike to protect it from being discolor by any sunlight and dirty through dust.
3. Checks
We recommend every 50 hours to review the screw connections for tightness, which were prepared in the assembly. Every 100
operating hours, you should put some spray oil at front & rear foot tube connection point and hand grip axle.
TROUBLESHOOTING
If you cannot solve the problem with the following information, please contact the authorized service center.
Problem
Computer has no value at
Display if you press any key.
Computer is not counting data
and do not switch on after start
cycling.
Computer is not counting data
and do not switch on after start
cycling.
No pulse value.
No pulse value.
Resistance don't change
Possible Cause
No Batteries insert or batteries empty
Sensor impulse missing base on not well
plugged connection.
Sensor impulse missing base on not
correct position of sensor.
Pulse cable is not plugged in.
Pulse sensors not well connected.
Connection of resistance not well
Solution
Check the position of batteries at battery compartment or replace
batteries.
Check the plug connections at computer and inside of handlebar
support.
Take o the cover and check the distance between magnet and
Sensor. The magnet at turning belt wheel should have only less
than < 5mm distance against the sensor position.
Check the separately pulse cable is well connected with
computer. Check the connections of the pulse cable.
Screw out the screw for pulse measurement and check if plugs
are well connected and no damage at pulse cable.
Check the resistance connection inside of handlebar support as
manual mention.
22
GB
Publicité
