SCHUBERTH E2 Manuel page 83

C. THE HELMET
3. Fasten the forehead pad to the 4
holders and connect the pins
with the corresponding plug-in devices.
4. Connect the 2 pins of the back pad with
the plug-in devices. Press the open end
over back pin of the cheek pad.
Installation the cheek pad
1. Loosen the velcro.
2. Slide the chin strap through the cheek
pad pocket.
3. Close the Velcro fastener. Make sure that
the tape is not twisted.
4. Connect the pins of the
cheek pads with the corresponding
plug-in devices.
5. Carefully place the cheek pad over
the velcro strip of the side pad.
6. Repeat points 1 to 5 for the
installation of the cheek pad on the
other side.
EN
83