Nilfisk ALTO NEPTUNE 1 Mode D'emploi page 16

NEPTUNE 1, NEPTUNE 2
NEPTUNE 2 Special
6 After using the cleaner
6.1 Switching off
the cleaner and
disconnecting supply
lines
6.2 Rolling up the electrical
lead and storing
accessories
6.3 NEPTUNE 1
Storing the cleaner
(below 0°C)
16
All manuals and user guides at all-guides.com
Store the cleaner in a dry room
without danger of frost or protect
as below:
1. Remove the water inlet hose
from the water supply.
2. Place the water inlet hose in
a bucket containing an anti-
freeze.
3. Remove the spray lance.
4. Switch on the cleaner with
the main switch in position
"Cold Water".
5. Operate the spray gun.
6. During suction operate the
spray gun two or three times.
7. The machine is protected
1. Close water tap.
2. Activate spray gun without
lance in order to empty all
residual water in the system.
3. Turn the main switch to posi-
tion „OFF".
4. Pull out the plug from the
electrical socket.
5. Squeeze the spray gun han-
dle until the cleaner is de-
pressurised.
6. Lock the safety catch on the
spray gun.
7. Remove the water hose from
the cleaner.
To prevent accidents, always
carefully roll up the electri-
cal lead and the high pressure
hose.
Place the spray lance into the
storage position.
against frost when antifreeze
solution emerges from the
spray gun.
8. Lock the safety catch on the
spray gun.
9. Remove the water inlet hose
from the bucket
10. Switch off the cleaner and
store it in upright position.
11. When the machine is put into
service again, the antifreeze
solution must be collected
and stored for future or prop-
er disposal.
1) Options / model variants
Original instruction