Nilfisk ALTO NEPTUNE 1 Mode D'emploi page 10

NEPTUNE 1, NEPTUNE 2
NEPTUNE 2 Special
3.4 Fill up fuel tank
NOTE!
At temperatures below 8° C, the fuel
oil begins to solidify (paraffin precip-
itation). This can lead to difficulties
in starting the burner. Before the
winter period either add a solidifica-
tion point / flow improver (available
from the fuel oil trade) to the fuel or
use winter diesel fuel.
3.5 Connecting the high
pressure hose
3.6 Connecting the water
supply
In the case of poor water quality
(sand, etc.), we recommend that a
fine water filter is fitted in the water
inlet.
We recommend the use of a textile-
reinforced water hose with a nomi-
nal diameter of min. 3/4" (19 mm).
10
All manuals and user guides at all-guides.com
With the machine cold:
Fill fuel tank from a clean con-
tainer with a fresh fuel, heating
oil, DIN 51603-1 (without bio
diesel) or Diesel EN 590 (Diesel
with a bio diesel content up to
7%).
Diesel according to EN 590 (up
to 7% bio diesel) can be used
with the following restrictions:
Maximum storage time in high
pressure cleaner diesel tank: 1
month.
Diesel stored externally for more
than 6 months is not allowed to
be filled into Nilfisk-ALTO high
pressure cleaners.
Diesel EN 590 is not recom-
mended for use in HPW's at an
ambient temperature below 0°C.
Diesel EN 590 from an open
container must not be used.
The fuel must be free from con-
tamination.
Tank capacity see chapter 9.4
Technical data.
Be careful not to damage the
fuel tank filter to avoid dirt
entering in the tank
1. Put the quick connector of
the high pressure hose onto
the nipple on the cleaner.
1. Rinse the water supply hose
briefly in order to prevent
sand an other dirt particles
entering into the machine.
2. Connect water supply hose
to the machine.
3. Open water tap.
NOTE!
See chapter 9.4 Technical Data for
required quantity of water and water
pressure.
1) Options / model variants
Original instruction
1)