Black & Decker KR703 Mode D'emploi page 8

ENGLISH
Even with the application of the relevant safety
regulations and the implementation of safety
devices, certain residual risks can not be
avoided. These include:
•
Injuries caused by touching any
rotating/moving parts.
•
Injuries caused when changing any parts,
blades or accessories.
•
Injuries caused by prolonged use of a tool.
When using any tool for prolonged periods
ensure you take regular breaks.
•
Impairment of hearing.
•
Health hazards caused by breathing dust
developed when using your tool (example:-
working with wood, especially oak, beech
and MDF.)
Use
Warning! Let the tool work at its own pace. Do
not overload.
Warning! Before drilling into walls, floors or
ceilings, check for the location of wiring and
pipes.
Selecting the direction of
rotation
For drilling and for tightening screws, use
forward (clockwise) rotation. For loosening
screws or removing a jammed drill bit, use
reverse (counterclockwise) rotation.
•
To select forward rotation, push the
forward/reverse slider (4) to the left.
•
To select reverse rotation, push the
forward/reverse slider to the right.
Warning! Never change the direction of rotation
while the motor is running.
8
All manuals and user guides at all-guides.com
Selecting the drilling mode
•
•
Setting the drilling depth (fig. A)
•
•
•
Switching on and off
•
•
•
For drilling in masonry, set the drilling mode
selector (5) to the position.
For drilling in other materials and for
screwdriving, set the drilling mode selector
(5) to the position.
Slacken the side handle (8) by turning the
grip counterclockwise.
Set the depth stop (7) to the desired position.
The maximum drilling depth is equal to the
distance between the tip of the drill bit and
the front end of the depth stop.
Tighten the side handle by turning the grip
clockwise.
To switch the tool on, press the variable
speed switch (1). The tool speed depends on
how far you press the switch. If the tool has a
variable speed control knob (3), set it to the
required speed range. As a general rule, use
low speeds for large diameter drill bits and
high speeds for smaller diameter drill bits.
For continuous operation, press the lock-on
button (2) and release the variable speed
switch. This option is available only at full
speed or at any speed preset with the
variable speed control knob (3). This option
does not work in reverse rotation.
To switch the tool off, release the variable
speed switch. To switch the tool off when in
continuous operation, press the variable
speed switch once more and release it.