Black & Decker KR703 Mode D'emploi page 7

•
If the supply cord is damaged, it must be
replaced by the manufacturer or an
authorised Black & Decker Service Centre in
order to avoid a hazard.
Features
This tool includes some or all of the following
features.
1. Variable speed switch
2. Lock-on button
3. Variable speed control switch
4. Forward/reverse slider
5. Drilling mode selector
6. Chuck
7. Depth stop
8. Side handle
Assembly
Warning! Before assembly, make sure that the
tool is switched off and unplugged.
Fitting the side handle and
depth stop (fig. A)
•
Turn the grip counterclockwise until you can
slide the side handle (8) onto the front of the
tool as shown.
•
Rotate the side handle into the desired
position.
•
Insert the depth stop (7) into the mounting
hole as shown.
•
Set the drilling depth as described below.
•
Tighten the side handle by turning the grip
clockwise.
All manuals and user guides at all-guides.com
Fitting a drill bit or screwdriver
bit (fig. B & C)
Keyless chuck with spindle lock (fig. B)
•
•
•
Keyed chuck (fig. C)
•
•
•
Removing and refitting the
chuck (fig. D)
•
•
•
•
•
•
Residual risks.
Additional residual risks may arise when using
the tool which may not be included in the
enclosed safety warnings. These risks can arise
from misuse, prolonged use etc.
Open the chuck by turning the sleeve (9)
counterclockwise.
Insert the bit shaft (10) into the chuck.
Tighten the chuck by turning the sleeve
clockwise.
Open the chuck by turning the sleeve (11)
counterclockwise.
Insert the bit shaft (10) into the chuck.
Insert the chuck key (12) into each hole (13)
in the side of the chuck and turn clockwise
until tight.
Open the chuck as far as possible.
Remove the chuck retaining screw, located in
the chuck, by turning it clockwise using a
screwdriver.
Tighten an Allen key into the chuck and strike
it with a hammer as shown.
Remove the Allen key.
Remove the chuck by turning it
counterclockwise.
To refit the chuck, screw it onto the spindle
and secure it with the chuck retaining screw.
ENGLISH
7