Publicité
Les langues disponibles
Les langues disponibles
Step 3b: Mounting to Concrete/Masonry
WARNING
• NEVER drill into mortar joints!
• Concrete must be 2000 PSI density minimum.
The wall plate can be mounted directly to concrete/masonry walls. Remove the tape strip
from the back of the template, and place the template in the desired location. Using a
bubble/laser level, align the template and then press the adhesive backing to the wall
which will hold the guide in place.
Note:
Depending upon the wall texture, you may need to use tape to hold the template in position.
Using a 1/2" (13 mm) masonry drill bit, drill 6 mounting holes 31/8" (80 mm) deep into the
concrete/masonry surface. Drill through the mounting hole cut-out sections of the template.
Carefully remove the template from the wall and discard. Hold the template in an upright position
so as not to spill the collected dust..
Insert wall anchors into the mounting holes,and lightly tap them flush to the wall with a hammer (Fig.3).
Masonry anchors MUST be seated firmly against the masonry or concrete. If mounting to a
masonry wall covered with drywall/plaster, counter sink a larger hole through the drywall/plaster
to the concrete/masonry surface overlapping the mounting hole, so that the anchor can be
seated directly against the concrete/masonry surface.
Step 3c: Mounting to Cinder Block
. Cinder Block must meet ASTM C-90 specifications.
. Mount to solid portion of block,generally 1" from the sides.
. NEVER drill into mortar joints!
. Use standard drill set on slow speed/high torque setting. DO NOT use hammer drill on cinder block.
. Verify that you have a minimum of 1 3/8" of actual concrete thickness in the mounting hole,
before inserting the wall anchor.
The wall plate can be mounted directly to cinder block walls.
Remove the tape stripe from the back of the template. Using a bubble level, hold the template in a
level position and then press the adhesive backing against the wall to hold the guide in place.
All manuals and user guides at all-guides.com
IMPORTANT
WARNING
Hammer
Gently
Push in
NB012010
Fig.3
5
Publicité
