Publicité
Liens rapides
Support avec inclinaison
Tilting wall mount for flat panels up to
•
90"
Maximum load 165 lbs
•
Adjustable tilt -14° to +5°
•
VESA 800mm x 400mm
•
Support mural pour écrans plats jusqu'à
•
90 po
Charge maximale 165 lb
•
Inclinaison ajustable de -14° à +5°
•
VESA 800 mm x 400 mm
•
Distributed by / Distribué par: Everik International Inc.
www.everik.com
EM-T5B
Wall mount with tilt
T5B.ME.112012.IM
Publicité
Manuels Connexes pour Evermount EM-T5B
Sommaire des Matières pour Evermount EM-T5B
- Page 1 EM-T5B Wall mount with tilt Support avec inclinaison Tilting wall mount for flat panels up to • 90” Maximum load 165 lbs • Adjustable tilt -14° to +5° • VESA 800mm x 400mm • Support mural pour écrans plats jusqu’à...
- Page 2 1-866-604-6966. • The EverMount EM-T5B is designed to mount a panel onto a vertical wall. Hardware for mounting to a wood stud is included. For mounting to any other surface, contact a qualified contractor.
- Page 3 Tools Required / Outils requis Phillips head screwdriver Tournevis à tête cruciforme Perceuse électrique avec foret de Electric drill and 10mm masonry bit maçonnerie 10 mm (3/8”)pour for concrete wall installation installation sur un mur de béton Ratchet or Driver with 13 mm Clé...
- Page 4 Step 1 - Connecting the Wall Plate together A. Thread part #1 and #2 together as shown in Figure 1. B. Slide all three part # 3 onto the top and bottom rods (1 & 2) as shown in Figure 2. C.
- Page 5 Step 2A - Mounting to the wall (Drywall): IMPORTANT!: For safety reasons, this mount must be secured to at least two wood studs no less than 16” apart. For panels heavier than 50 kg (110 lbs), three studs are recommended. The studs must be capable of supporting the combined weight of the mount and flat panel.
- Page 6 Step 2B - Mounting to the wall (Concrete): A. Place the wall plate against the wall in the desired location. Slide the sections of the mount that contain the bolt holes so that they are evenly spaced apart from each other (see Fig.1). Make sure the mount is level. B.
- Page 7 Step 3 - Attaching the mount arms to your flat panel: A. Determine the correct length of screw to use by checking your panel’s mounting screw requirements or by checking the back of the panel. If the back of your panel is flat and the mounting holes are flush with the surface, use the shorter screws (D or F).
- Page 8 Fig.7 Step 4 - Final assembly: A. Make sure the safety mechanisms located at the bottom of each mount arm are as low as possible. Loosen the screws to lower them (see Fig.7). B. With the help of another person, carefully lift the flat panel onto the wall plate.