Evermount EM-WB1 Instructions D'assemblage Et D'installation

PLEASE READ THESE INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE! IF YOU DO
NOT UNDERSTAND THE INSTRUCTIONS, OR DO NOT FEEL THAT YOU CAN FOLLOW THEM SAFELY,
CONTACT A QUALIFIED CONTRACTOR. THE WARRANTY WILL BE HONOURED IF ACCOMPANIED BY
AN ORIGINAL SALES RECEIPT, AND ONLY IF THE INSTRUCTIONS HAVE BEEN FOLLOWED EXACTLY.
Before beginning, please check to ensure you have all the parts listed below. To acquire missing parts please
visit www.everik.com/parts.html or call 1-866-604-6966.
•The EverMount EM-WB1 is designed to mount a plasma or LCD monitor onto a vertical wall.
•Hardware is included for mounting to wood studs. For mounting to any other surface, contact a qualified contractor.
•This product will hold flat screens from 26 to 42 inches and weighing up to 110 lbs.
•You will need a Phillips screwdriver, a level, and a drill with a
•A second person will be required to assist with steps 3 and 4.
1) Using monitor screws (part D) with washers (part E), attach the slotted arms of the monitor brackets (part B) to the
back of your plasma TV. Use spacers (part G, optional depending on your TV model) as needed between brackets
and monitor. Ensure that hooks are at the top of the brackets. (See diagram)
2) Wall Plate: This plate must be installed in a wood stud or equivalent!
i) Verify stud location.
ii) Using wall plate (part A) as template, mark locations for wall plate bolts (part F) on wall using small holes
along bottom and top of wall plate. At least two of these holes must align with a stud. Bolt wall plate
(part A) to wall using wall plate bolts (part F).
3) Securing monitor to wall plate: Lift the entire monitor with monitor brackets (part B) attached.
i) Place the hooks of the monitor brackets' solid arm over the top track of the wall plate (part A). (See diagram)
ii) Lower the monitor into position, so that the bottoms of the monitor brackets (part B) are resting below the
bottom track of the wall plate (part A).
iii) Insert the securing knob (part C) into the bottom of each monitor bracket (part B). See diagram.Tighten until
snug.
4) Adjusting the tilt: Using the T-handle Allen key (part H), change the tilt of the monitor by adjusting the bolts shown in
the diagram, from the back of the monitor brackets. Ensure that a second person is supporting the screen while the tilt
is adjusted.
Note: Keep the T-Handle Allen Key in a safe place for future adjustments when needed.
Description
Part
A Wall Plate
B Monitor Bracket
C Securing Knob
D Monitor Screw
(Small, medium or large)
E Washers
(Small or large)
F Wall Plate bolt
G Spacers (large or small)
H T-handle Allen key
D E F G
H
All manuals and user guides at all-guides.com
ASSEMBLY INSTRUCTIONS
Qty
1
2
A
2
4
4
Stud
4
4
1
C
3/16" bit.
Top Track of Wall Plate
Bubble Level
Adjust for Tilt
B
EM-WB1
Stud
F
Bottom Track of
Wall Plate
C
B