Evermount EM-PLA Guide D'installation page 10

All manuals and user guides at all-guides.com
Fig.16
The tilt lever includes a ratchet function, so that it can be lifted and
repositioned for the next turn. To operate the ratchet, pull the lever tilt knob
straight out, rotate it to an unobstructed position, release the lever,
and then turn it in the desired direction. Repeat as necessary until
the tilt tension is set properly (Fig.16).
Swivel- Adjust the flat panel display for off center viewing positions.
Grasp the side edges of the display and then swivel display into its desired
position (Fig.17).
Fig.17
Panning - Positions the flat panel display at an angle to the wall for viewing
from opposite sides of the room.
Grasp the side edges of the display and then swivel and pull the display
into desired position (Fig.18).
Fig.18
Retracting the Flat Panel Display - Positions the display against the wall.
Grasp the side edge of the display, swivel and pull the display into the center
position (Fig.19), and then gently push the display straight back towards the
Fig.19
wall into the retracted position (Fig.20).
Note:
Use care when moving the display to ensure that cables do not
become stretched or pinched.
Fig.20
Maintaining the EM-PLA
The arm assembly and wall plate may be cleaned with a soft sponge and mild solution of soap
and water.
Caution: Be sure not to get moisture on the electrical connections or the display.
10
NB012010