Ga.Ma SALON EXCLUSIVE GT905 Manuel De L'utilisateur page 9

REMOVAL OF THE INTERCHANGEABLE HEADS:
The method for removal of the two heads is identical.
To remove the heads, grasp the beard trimmer by the front side, place your thumb over the head and push
backwards until the head is completely removed.
INSERTION OF COMBS:
The supplied combs have two concave hemisphere-shaped lateral slots, while the appliance has two convex
hemisphere-shaped lateral slots. To insert them on the beard trimmer, place the hemispheres found on the
combs on the hemispheres found on the appliance and lightly push until you hear a slight click: the insertion
procedure is now complete. To remove the combs just extract them making the combs slide outwards.
CUTTING LENGTH ADJUSTMENT:
The GT905 beard trimmer offers the possibility of making finishing touches with cutting length varying
between 0.8 mm to 1 mm (if used without any guide comb attached) and performing classic hair cuts with the
following lengths: 3, 6, 9 and 12 mm.
CLEANING AND MAINTENANCE:
A clean and properly lubricated beard trimmer considerably improves its capacity and cutting precision.
DO NOT CLEAN ANY PART OF THE APPLIANCE UNDER RUNNING WATER.
CLEANING THE HEAD:
Before any cleaning operation, make sure that the appliance is properly turned off and disconnected from the
power outlet. Remove the accessory if it is inserted. Using the special brush supplied, remove any hair
residues between the blades and the back of the blade head.
NEVER DISASSEMBLE THE HEAD OF THE BLADE OR YOU WILL INVALIDATE THE WARRANTY ON
THE ENTIRE PRODUCT.
HOW AND WHEN TO LUBRICATE THE BLADE:
Before the first use we recommend lubricating the blade with a drop of the oil found in the package or with
any other lubricating oil (make sure that it is not too viscous).
Turn the beard trimmer upside down (Fig. 1) so that oil does not drip on the appliance. Lubricate the blade
with a few drops of oil. Turn the appliance on for a few seconds so that the oil is distributed evenly along the
entire blade. Then, using a dry cloth, eliminate any excess oil residues.
13
We recommend repeating this procedure every two months or more often, depending on product use.
Fig.1
BLADE DURATION:
The duration of the blade varies based on usage frequency and times. Although correct maintenance is
performed, if the cutting efficiency is compromised, contact the manufacturer to have the entire head
replaced.
You can find the product manuals and warnings on the site www.gamaprofessional.com
The date of production of this model mentioned on the box label in the format:
XXX - number of goods part; XX - day; XX - month; XX - year
14