Change Of Door Opening Direction - Electrolux ERC 2450 Mode D'emploi

Change of door opening direction

Should the setting-up place or handling demand it,
door-opening direction can be refitted from right-
handed to left-handed.
Following operations are to be done on the basis of
figures and explanations:
Pull out the plug from the mains socket.
Tilt back the appliance carefully being careful so
that the compressor can not touch the floor. It is
recommended to ask another person for help, who
can keep the appliance at this position safely.
Unscrew the adjustable feet situated on both sides
(2 pieces), in addition the screws fixing the lower
door holders (3 pieces) respectively the screw on
the other side.
Put over the pin in the lower door holding plate in
the direction of the arrow.
Fix the plate on the other side leaving the position
of the door unchanged.
Then screw in the one screw in the place set free
on the other side as well as the adjustable feet
(2 pieces) and set up the box.
For refitting the upper door holder take out the
screws (2 pieces) fixing the plastic top on the back
of the box.
Push back the top and lift it from the fixing
elements.
Unscrew the screws fixing the upper door holder
(2 pieces).
After unscrewing turn over the pin in the door
holder plate in the direction of the arrow.
Fit and fix the door holder plate on the other side
without displacing the door.
Put back the plastic top on the fixing elements and
pull it forward.
Fix the top with the screws (2 pieces) on the back
side of the box.
Put over the handle and the plastic nails on the
other side.
Put the appliance to its place, set it level and plug it
into the mains socket.
GB
63