Change Of Door Opening Direction; Electrical Connection - Electrolux Zanussi ZRX7JB Mode D'emploi

G G B B
If it is unavoidable because of furnishing and the
appliance has to be stood near a cooker take these
minimum distances into consideration:
In case of gas or electric cooker 3 cm must be left,
when it is less put a 0,5 - 1 cm non-flam insulation
between the two appliances.
In case of oil or coal-fired stove the distance must be
30 cms since they give off more heat.
The refrigerator is designed to operate when it is totally
pushed to the wall.
When placing the refrigerator keep minimal
distances recommended in figure.
A : placing it under a wall-cupboard
B : placing it freely

Change of door opening direction

Should the setting-up or handling demand it, door-
opening direction can be refitted from right-handed to
left-handed.
Following operations are to be done on the basis of
figures and explanations:
Break the circuit of the appliance.
Take the covering of top door holder off, unscrew the
screws fixing the top door holder (2 pieces) and take
it off according to figure.
Take the door off.
40
Unscrew the screws fixing the lower door holder (2
pieces) and remove it according to figure.
Fix lower door holder on the other side.
Fit the door to the lower door holding pin.
To fit top door holder remove plastic coverings of
door holder holes carefully (e. g. with a knife) and put
them on the other side.
Fix top door holder with 2 screws in the place set free
being careful that the edge of the door is parallel with
the side of cupboard.
Put the covering of top door holder back.
Put over the handle and the plastic nails on the other
side.
In case you do not want to perform the procedures
above, call the nearest brand-mark service. Technicians
will accomplish the refitting expertly for charge.

Electrical connection

This refrigerator is designed to operate on a 230 V
AC ( ~ ) 50 Hz supply.
The plug must be put into a socket with protective
contact. If there is no such, it is recommended to get
an electrician to fit an earthed socket in compliance
with standards near the refrigerator.
This appliance complies with the following
E.E.C. Directives:
– 73/23 EEC of 19.02.73 (Low Voltage Directive) and
subsequent modifications,
– 89/336 EEC of
Compatibility Directive)
modifications.
03.05.89 (Electromagnetic
and subsequent