Part Names; Front Panel - Onkyo TX-8260 Mode D'emploi

> Before Start > Part Names

Part Names

Par t Names


Front Panel

1. Í ON/STANDBY button
2. MENU button: Used to display the menu.
MEMORY button: Used to register AM/FM radio stations.
3. Play (1)/Pause (;) button,TUNING MODE button:
0 Used for play operations when playing Music Server or USB.
0 Switches tuning to an AM/FM station between automatic tuning and manual tuning
4. HYBRID STANDBY indicator: Lights if the unit enters standby mode when the features
such as NET Stby are enabled that continue to work when this unit is in standby.
5. Remote control sensor: Receives signals from the remote controller.
0 The signal range of the remote controller is within about 16y/5 m, at an angle of 20° on
the perpendicular axis and 30° to either side.
6. ZONE 2 button: Controls the multi-zone function (P27).
4
> Install
    
   
> Initial Setup > Playback
 
  
7. OFF button: Switches the multi-zone function off (P27).
8. Display (P5)
9. SETUP button: You can show advanced setting items on the display to provide you with
an even better experience (P31).
10.Cursors (D / C / B / A), ENTER button: Select the item with the cursors and press
ENTER to confirm. Use them to tune to stations when using TUNER.
11. RETURN button: Returns the display to the previous state during setting.
12.VOLUME
13.PHONES jack: Connect stereo headphones with a standard plug (Ø1/4"/6.3 mm
diameter).
14.DIMMER button: You can adjust the brightness of the display in three steps. It cannot be
turned off completely.
15.SPEAKER A/B button: Select the terminals to output audio from between SPEAKERS A/B.
16. INPUT dial: Switches the input to be played. Turn the control to switch the source in the
Supplementary information | Advanced Setup | Others
  
 
