Télécharger Imprimer la page

CAMSO 5000-03-1772-MAN Manuel D'installation page 4

Publicité

INFORMATION
1. For installation purposes, directional arrows have
been cut out of some components in the anchor
bracket kits. These arrows indicate the front of the
vehicle relative to the component. See Fig. 1
Fig. 1
2. Identify the mounting position of each Track System
undercarriage unit; the position is indicated on a
small sticker affixed on the undercarriage frame.
See Fig. 2
Fig. 2
PREPARATION
WARNING
Do not place any part of your body under the
vehicle
unless
it
appropriate stands. Severe injuries could occur if
the vehicle collapses or moves. Do not use a
lifting device as a secure stand.
1. Position the vehicle on a flat and level surface, shift
the transmission to neutral and turn off engine.
2. Set each Track System unit near the position
indicated by the sticker affixed on the frame.
is
securely
placed
REAR TRACK SYSTEM INSTALLATION
1. Using a lifting device, raise the rear of the vehicle
and install appropriate stands. Ensure that the
vehicle is immobilized and safe to work on.
2. Remove rear wheels. Make sure that wheel studs
and wheel hubs are free of dirt.
3. If needed, remove CV joint protectors.
4. Remove bolt, washer and spacer bushings from the
rear stabilizing rod end. Discard the M10x80 mm
bolt and the tapered spacer bushing from the
disassembled set of parts. See Fig. 3
Discard
5. Remove the two lower nuts (1) from the group of
four located inside the rear suspension trailing arm.
See Fig. 4 and Fig. 5
on
4
Fig. 3
Fig. 4

Publicité

loading