Kohler Sensate K-72218-WB-BL Instructions D'installation page 6

Ø 3"
(76 mm)
Min
Supply Hose
Check
Valve
3. Connect the Supplies
CAUTION: Risk of restricted water flow and product damage.
Supply hoses must not be taut, kinked, or twisted during
installation. If the supply hoses must be coiled, maintain an inside
diameter (ID) of 3" (76 mm).
CAUTION: Risk of fresh water contamination. To prevent water
contamination, the check valves must be installed.
Connect the Supplies
Assemble a check valve to each supply.
Connect and tighten the supply hoses to the check valves.
Place a bucket under the outlet hose.
Turn on the supplies.
Flush the hot and cold water for 1 minute to remove any debris.
Connect the flow sensor to the solenoid inlet.
Connect the outlet hose to the flow sensor inlet.
Connect the Spray Hose
1318209-2-A
All manuals and user guides at all-guides.com
Solenoid
Outlet
Outlet Hose
Weight
Spray
Hose
6
Inlet
Outlet
Hose
Kohler Co.