Kohler Sensate K-72218-WB-BL Instructions D'installation page 18

Troubleshooting (cont.)
Faucet Troubleshooting Table
Symptoms
2. Low water flow.
3. Poor spray
pattern.
4. Power LED is not
lit.
1318209-2-A
All manuals and user guides at all-guides.com
Probable Causes Recommended Action
D. The outlet D. Confirm that the
hose is solenoid valve is
kinked. located within 7" (178
mm) to 8" (203 mm) of
the faucet centerline.
E. Refer to the "Cleaning
E. One or more
screens are the Screens" section.
clogged.
A. The supply A. Confirm that the
stops are supply stops are fully
partially open.
closed.
B. Handle is B. Rotate the handle to the
partially full open position.
closed.
C. The hot C. Confirm that the
and/or cold supply hoses are not
supply hose kinked or twisted. If
is kinked or coiled, maintain an ID
twisted. of 3" (76 mm).
D. The outlet D. Confirm that the
hose is solenoid valve is
kinked. located within 7" (178
mm) to 8" (203 mm) of
the faucet centerline.
E. Refer to the "Cleaning
E. One or more
screens are the Screens" section.
clogged.
Cracked Replace the solenoid
F. F.
diaphragm. valve assembly.
A. The spray A. Rub your finger over
nozzles are the nozzles with water
clogged. running to dislodge
debris.
A. No power to A. Check the power
the circuit supply connections to
board. the circuit board.
18 Kohler Co.