Publicité
Les langues disponibles
Les langues disponibles
Operation
This mower is intended for residential use only.
POTENTIAL HAZARD
When extension cord is connected to mower
and plugged into a normal household
outlet, the mower is operational. Someone
could accidentally start the mower.
WHAT CAN HAPPEN
Accidental starting of mower could
seriously injure you or other bystanders.
HOW TO AVOID THE HAZARD
Always remove extension cord from mower
receptacle when leaving mower unattended,
even for a short period of time.
Starting/Stopping Instructions
To Start Motor
1.
Connect extension cord to mower (Fig. 12).
2.
Plug other end of extension cord into a normal
household outlet.
3.
Pull control bar toward handle while pushing
down slide on control (Fig. 14).
4.
Squeeze control bar to handle (Fig. 15).
To Stop Motor
1.
Release control bar.
2.
Disconnect extension cord from mower if mower
will be unattended for any period of time.
Mowing Tips
General Mulching Tips
Your mower is designed to mulch grass when the
mulch door is completely closed (Fig. 7). Follow
these instructions whether cutting grass or leaves for
the best cutting results and lawn appearance:
Maintain a sharp blade throughout the cutting
season. Periodically file down nicks on blade.
Only mow dry grass or leaves. Wet grass and
leaves tend to clump on yard and may cause
mower to plug or motor to stall. They may also
be slippery to walk on and could cause you to
slip and fall.
POTENTIAL HAZARD
Wet grass or leaves can cause you to slip
and contact blade.
WHAT CAN HAPPEN
Blade contact can seriously injure you.
HOW TO AVOID THE HAZARD
Mow only in dry conditions.
Clean clippings or leaves from underside of
mower deck after each mowing.
Grass grows at different rates at different times
of the year. In the heat of summer, it is generally
best to cut grass at the 2 / ", 3" or 3 / "
height-of-cut settings. Only about / of the
grass blade should be cut off. Cutting below the
2 / "setting is not recommended unless grass is
sparse or it is late fall when grass growth begins
to slow down.
When changing height-of-cut from the
established setting (ex. 2 / ", 3" or 3 / ") to a
lower height, the grass may appear ragged or
uneven until the grass adjusts to the new
established height-of-cut and regains its normal
appearance.
When cutting grass over six inches tall, you may
want to first mow using the side discharge chute
or try the highest height-of-cut setting and a
EN–8
Publicité
