IKA Tube Mill 100 control Mode D'emploi page 21

Milling tube coupling broken:
The milling tube coupling may be broken when the
grinding material is too much or too hard.
Pull the broken coupling out from the drive unit:
 Fit the coupling extractor in clockwise direction. The
coupling puller is properly attached to the coupling af-
ter a "click".
 Turn the coupling extractor in counterclockwise direction.
The broken coupling will be extracted out after a "click".
The instrument is maintenance-free. It is only subject to
the natural wear and tear of components and their statisti-
cal failure rate.
Cleaning:
Disconnect mains plug prior to
cleaning!
- Wear protective gloves when cleaning the devices.
- Do not place electrical appliances into the cleaning
agents for cleaning purposes.
- Do not allow moisture to get into the appliance when
cleaning.
- Please consult IKA before using any cleaning or decon-
®
tamination methods, other than those recommended here.
- The device must not be washed in a dishwasher.
- The protective hood is of polycarbonate and can be treat-
ed using commercially-available disinfectants. Avoid prod-
ucts that contain aldehydes, phenols, acetone or alcohol.
- It should be cleaned only by hand using a liquid disinfectant.
- The only cleaners or disinfectants that may be used are
those that:
- lie in the pH range 5 - 8,
- contain no corrosive alkalis, peroxides, chlorine com-
pounds, acids or brine.
- If rotator becomes contaminated with milled material,
clean it thoroughly with vacuum cleaner.
Only clean IKA ® appliances using these IKA
cleaning agents. To remove use:
Dirt Cleaning agent
Dyes isopropyl alcohol
(do not use for the protective hood)
Building materials water containing detergent, Isopropanol
(do not use for the protective hood)
Cosmetics Water containing detergent, Isopropa-
nol (do not use for the protective hood)
Food Water containing detergent
Fuels Water containing detergent
Other materials Please consult IKA
Using the coupling extractor
Maintenance and cleaning
After the device is used some time, the screw cap should
be cleaned as following:
 Unscrew the screw cap.
 Disassemble the screw cap.
 Clean the parts of the screw cap, e.g. with vacuum
After cleaning, the screw cap can be installed back to the
device in the reverse sequence.
® approved
®
I
II
CLICK

cleaner.


Spare parts order:
When ordering spare parts, please give:
- Machine type.
- Serial number, see type plate.
- Item and designation of the spare part,
see www.ika.com, spare parts diagram and spare parts list.
- software version.
Repair:
Please send instrument for repair only after it has
been cleaned and is free from any materials which
may constitute a health hazard.
For this you should request the "Decontamination Cer-
tificate" from IKA ® , or use the download printout of it
from the IKA website www.ika.com.
®
Return the instrument in its original packaging. Storage
packaging is not sufficient. Also, please use suitable ship-
ping package material.
III
CLICK


21