ECOFOREST ecoGEO HP Serie Manuel D'installation page 35

Direct installation
In simple heating / cooling systems, ecoGEO heat pumps can be installed directly into the distribution system, in systems with
underfloor heating, low temperature radiators and convectors.
AI20
T
DI1 EVU
DI2
DO1
AO1
DO12
Figure 1.7. Wiring scheme directly to the heating / cooling system (ecoGEO HP1 and HP3 models).
T AI20
DI1 EVU
DI2
DO1
AO1
DO12
Figure 1.8. Wiring scheme using a single buffer storage tank (ecoGeo HP1 models).
Installation using buffer storage tanks
If required by the application, the heat pump can also be connected to the heating / cooling system by buffer separator tanks. To
do so, it is equipped with two temperature probes that are used to control a buffer storage tank for heating and a buffer storage
tank for cooling. In installations where there is only one buffer storage tank for heating and cooling, both probes have to be
All manuals and user guides at all-guides.com
DI3
T AI12
DO4
DO3
AI11
T
DO2
DO17
AO2
DI3
AI12 DO5
T
DO4
DO3
AI11
T
DO2
DO17
AO2
34
Installer manual ecoGEO HP
T DI4
T AI19
DI5 DI7
T T
DI6 DI8
T T
AI13 T AI14
DO7 DO8
DO5 DO6 AO3 AO4
SG2 SG3
DG1
DO12
DI4
T AI19
DI5
T T
T DI6 T
AI13
T
DO7
DO6 AO3
SG2
DG1
AI17
T
DO18
DO12
FBus2
DI9 DI11 DI13
T T T T
DI10 DI12 DI14
T T T T
T AI15 T AI16 T
DO9 DO10
AO5 AO6
SG4 SG5
FBus2
DI7 DI9 DI11 DI13
T T T T
DI8 T DI10 T T DI12 T DI14
AI14 AI15 AI16
T T T
DO8 DO9 DO10
AO4 AO5 AO6
SG3 SG4 SG5