Metabo HPT GP 18DA Instructions De Sécurité Et Mode D'emploi page 17

<GP18DB> (Fig. 12)
To switch on, slide the off -lock lever in the direction of
Ⓐ and press the paddle lever in the direction of Ⓑ as
shown in Fig. 12. Release the paddle lever to switch
off .
Paddle lever
Ⓑ
Mode
Transmission
Dial Settings
Auto
Off -lock
lever
Ⓐ
Fig. 12
Status
1
2
3
4
5
A
2. About the mode change function
The unit has "Transmission mode" and "Auto mode".
○ With Transmission mode, the grinder's number of
revolutions can be set at one of fi ve stages.
When operating in Transmission mode, the set
number of revolutions will be maintained regardless
of changes in load.
○ With Auto mode, you can lower noise and vibration by
lowering the maximum number of revolutions while in
a no-load state.
While in Auto mode, the number of revolutions will be
raised if the load becomes greater during operation.
On the other hand, the number of revolutions will
be lowered if the load decreases during operation.
(Table 6)
○ Set the mode and dial according to work application.
Table 6
Number of Revolutions (/min)
7,000
13,800
16,600
24,400
29,000
15,000
29,000
English
Dial
Fig. 13
Use
Polishing/fi nishing
Paint removal
Rust removal
Burr removal
Grinding
Work on standby
Grinding
17