Publicité
Les langues disponibles
Les langues disponibles
1. Drill a pilot hole for the sliding door guide (N) using a ø3mm (1/8in) drill bit.
2-3. Drill a pilot hole for the roller guide track's anchor (P) using a ø6mm (1/4in) drill bit. Insert the wall anchors (GG)
using a rubber mallet until the wall anchors are flush with the wall.
4. Install the sliding door guide (N) with the screw (CC) and the cap (II).
5-6. Install the roller guide track's anchor (P) onto the roller guide track (O) using the screw (BB) and the cap (II).
1
Φ 3mm
1/8in
3
GG
5
P
BB
II
O
FIXED PANEL INSTALLATION
11
2
Φ 6mm
1/4in
4
II
CC
N
6
Publicité
