Advice And Safety - Opus Technologies DCL20-65 Manuel D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DCL20-65 | Manuel d'installation et d'utilisation | Installation and user manual |

2.4 Advice and safety

Most of defective loop installations are the result of
a lack of preparation. Take your time before starting
your installation and always keep this manual in an
accessible place.
Ideally, the loop amplifier should be placed under a
desk or counter and the loop installed as shown in
the illustration below. The amplifier should be
installed in an area not accessible to children or
unauthorised personnel. When choosing the location
of the loop, take into account the possible future
installation of other equipment. Place the system at
the point of contact the most frequently used by
customers/visitors.
• To prevent accidents or personal injury caused by
electrical shocks, never place any type of
container filled with a liquid, such as a vase, on or
around the device.
• Never pull on the power cord to remove the plug
from the wall outlet; always pull the plug.
• Do not operate the device near heat sources or in
rooms
with
high
temperature range 0-45°C).
• Depending on the stress it is exposed to, the
device can develop high temperatures. Be careful
not to touch these elements - risk of burns!
• An installation must be carried out by qualified
personnel.
• The device must be out of reach of unauthorized
persons.
humidity.
(Operating
• The device may only be operated by trained
staff qualified for loop installation.
• The device is intended to be used for inductive
loop systems only.
• To prevent potential injury, do not position
this device higher than 2 meters from the
ground
• Connect the loop driver only to wiring which
complies to IEC-60364.
• THE
AMPLIFIER
MUST
/GROUNDED
• Refer all servicing to a qualified staff. Servicing
is required when the device has been damaged
in any way, such as a power supply cord or
plug is damaged, liquid has been spilled or
objects have fallen into the device, if it have
been exposed to any rain or moisture, does
not operate normally or has been dropped
• TO PREVENT ELECTRIC SHOCK DO NOT
REMOVE THE COVER. THERE ARE NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED STAFF
20
BE
EARTHED

Publicité

Chapitres

Table des Matières
loading

Table des Matières