Opus Technologies DCL20-65 Manuel D'installation Et D'utilisation page 22

DCL20-65 | Manuel d'installation et d'utilisation | Installation and user manual |
Loop2
Position the loop on the top horizontal part of
2.
the counter- while positionning the cable as close
as possible from the customer.
Install the loop on the vertical countertop by
3.
positioning the cable as close as possible from
the customer.
Install the loop using the binding clips supplied.
For better durability, it may be appropriate to
install the loop in a plasticchute.
Then connect the link cable to the amplifier"
terminal block "amplifier". Connect the loop the
the "loop" terminal block of the amplifier.
Screw the connector at the drawn cross level.
Attention, warning, danger:
The loop must not be positioned
under a metal structure. The ma-
gnetic field would be absorbed by
the metal mass and would leading to
unproper audio coverage. There are
other solutions to install a loop on a metallic
counter (see figure 3)
amplifier
Loop1
Figure2.
For greater coverage around the counter, it is
possible to install a cable on the floor. The loop
can be placed in the slab (over the wire mesh),
under a coating (parquet, carpet, etc.) using a
copper tape or glued under a carpet as shown in
figure 3.
Loop
The wire supplied in the DCL20-65 kit produces a
magnetic field radiating on a perimeter of 1.2m
which allows a people to receive the signal com-
fortably.
The pictogram with an integrated loop can be
fixed on the desk and turned to the customer's
side to avoid disturbances due to metal (see Fi-
gure 4).
22
amplifier
Figure3.
Loop
amplifier
Figure4.