Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DCL20-TV | Manuel d'installation et d'utilisation | Installation and user manual |
17
2.4 Safety notes
The majority of problems with the hearing loop
happens when the installation has not been
properly reflected so let's take while before
starting the installation tobetter results and
time saving.
Ideally, the loop amplifier should be placed near
the area to be covered. This may involve placing
the amplifier on a panel, under a desk or under
a table.
The pickup microphone should be as close as
possible to the input of the amplifier.
The amplifier should be placed closer to the au-
dio source (television, sound ... etc).
To position the loop in the space to be
equipped, it is important to take into account
the final users of the system.
For example, if the place is planned for a con-
versation between a speaker and the costu-
mers, a loop around the desk may be a better
solution rather than a loop around the perime-
ter of the room. It will limit radiation and in-
crease confidentiality. For the equipment of a
TV lounge, it is advisable to pull the loop around
the room to allow several users to use the
equipment.
Publicité
Table des Matières
