Connections And Settings; Loop And Power Connection - Opus Technologies DCL20-TV Manuel D'installation Et D'utilisation

DCL20-TV | Manuel d'installation et d'utilisation | Installation and user manual |

4. Connections and settings

4.1 audio connection
Ligne/ Mass
To connect your TV to the DCL20, connect the
cable provided in line input 1.
Connecting to an intercom or specific source:
Connect your source to input 2 of the DCL20.
This input supports the following sources: line,
low impedance and 100V with a adapter.
Micro input 1:
Type : Jack 3,5
Feature: phantom power
Input ligne 1:
Type: Terminal Block
Input type: Line or microphone, screw connec-
tion.
Input 2:
Type: Terminal Block
Input type: Line / 100V / low impedance
micro /Ligne/ Mass
Jack 3,5

4.2 Loop and power connection

Connect the loop cable to the "Loop" input on
the DCL20.
Note:
Loop input does not impose any sense
of connection
Power supply: Connect the power supply pro-
vided in the kit to the "Power supply" input
AC / DC connector
5 x 2,1 mm
19