Troubleshooting; Specifications - Sony SCD-1 Mode D'emploi

Troubleshooting

If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There is no sound.
, Check that the player is connected securely.
, Make sure you operate the amplifier correctly.
, Check that the BALANCED OUT ON/OFF switch
is set to ON if you connect an XLR (balanced) cord.
There is no sound from the DIGITAL OUT
connectors.
, The audio signals of the super audio CD cannot be
output from the DIGITAL OUT connectors.
, Press DIGITAL OUT to display "16 bit" in the
display when the player is playing the CD.
The disc does not play.
, There is no disc inside the player.
, There is no stabilizer on the disc.
, The disc is placed upside down on the tray.
, Place the disc on the disc tray with the label side
up.
, The disc is placed at an angle. Reload the disc and
the stabilizer.
, Clean the disc (see page 21).
, Moisture has condensed inside the player. Remove
the disc and leave the player turned on for about
an hour (see page 20).
, There is an incompatible disc on the tray (see page
7).
, Clean the turntable (see page 21).
The remote does not function.
, Remove any obstacles in the path of the remote
and the player.
, Point the remote at the remote sensor on the
player.
, If the batteries in the remote are weak, replace
with new ones.
22
GB

Specifications

When a super audio CD is played
Playing frequency range 2 Hz to 100 kHz
Frequency response 2 Hz to 50 kHz (–3 dB)
Dynamic range 105 dB or more
Total harmonic distortion rate
0.0012 % or less
Wow and flutter Value of measurable limit (±0.001 %
W. PEAK) or less
When a CD is played
Frequency response 2 Hz to 20 kHz
Dynamic range 100 dB or more
Total harmonic distortion rate
0.0017 % or less
Wow and flutter Value of measurable limit (±0.001 %
W. PEAK) or less
Output connector
Jack type Output level
LINE OUT Phono 2 Vrms
UNBALANCED jacks (at 50 kilohms)
LINE OUT XLR 4 Vrms
BALANCED (at 50 kilohms)
DIGITAL OUT Square –18 dBm
OPTICAL* optical
output
connector
DIGITAL OUT Coaxial 0.5 Vp-p
COAXIAL* output
connector
*Output only the audio signals of the CD
General
Laser Semiconductor laser (λ = 780,650 nm)
Emission duration: continuous
Power requirements
European models: 230 V AC, 50/60 Hz
USA and Canadian models:
120 V AC, 60 Hz
Power consumption 36 W
430 × 149 × 436 mm
Dimensions (w/h/d)
(17 × 5
parts
Mass (approx.) 26.5 kg (58 lbs 7 oz.)
Supplied accessories
See page 4.
Design and specifications are subject to change without notice.
Load impedance
Over 10 kilohms
Over 600 ohms
Light emitting
( )
wave length:
660 nm
75 ohms
× 17
7 1
/ / in.) incl. projecting
8 4