Advanced Elements ATTACK PRO Manuel Du Propriétaire page 9

Attack Pro Inflatable Kayak Owner's Manual
TM
3.3 INFLATION
Foot Brace Location
IMPORTANT: Inflate your kayak in the following order. Failure to follow these instructions
may cause damage to your kayak. Do not over inflate. Be sure to read directions on operating
the valves in the section "Understanding Your Valves".
1. Attach thigh straps to front d-rings located in bailing wells and rear d-rings located on side
walls directly behind kayak seat.
2. Insert foot brace tracks into webbing mounting pockets located on kayak main chambers
before inflation. Orient each of the foot pegs so that the adjustment tab on the foot plate is facing
towards the bow of the kayak. First insert the foot peg track into the webbing loop nearest to the
seating area and then insert the other end of the track into the webbing pocket at the bow of the
kayak. (See Figures, Steps 1-4 on next page).
3. Check to be sure all 3 valve plungers are in the UP or Inflate position. (See Figure 1).
4. Using the adaptor located in your repair kit, inflate Main Chamber 1 until firm to the touch
(2.25 psi ONLY).
5. Inflate Main Chamber 2 until firm to the touch (2.25 psi ONLY).
6. Inflate Floor Chamber "3" until firm (4-6 psi MAX).
7. Make sure all valves are closed tightly and properly.
8. Attach kayak seat and adjust for desired support.
9. Adjust foot pegs for desired bracing by depressing the tabs on the foot plates and sliding along
tracks.
9