Publicité
Les langues disponibles
Les langues disponibles
7. TROUBLESHOOTING
PROBLEM
Does not hold air while
inflating:
The kayak is sagging or
under inflated:
The kayak will not hold
full pressure for more
than a couple of hours:
Kayak still loses air:
14
SOLUTION
The spring valve uses a plunger system. The only time the plunger
should be in the open position is when you are deflating. Make sure
that the plunger is closed to inflate. Push the plunger in and rotate
counter-clockwise.
Be sure that the right pump is being used. You need a bellows foot
pump or a double action hand pump. A 12-V electric does not
supply enough pressure to fully inflate the kayak. The 12v can be
used to partially inflate the kayak but one of the other pumps is
needed to top it off.
Make sure that the plunger is in the closed position. It should only be
open when deflating. If it is open, the only seal is the black rubber
gasket inside the cap. Even then, a little air may still leak out.
If you have checked all the previous possible reasons for the kayak
losing air, then there may be a pinhole or a puncture somewhere on
the tube. Inflate the air chamber that is loosing air. If you cannot see or
hear where a leak may be, take a clean rag with soapy water and begin
rubbing the tube. If a hole is present, bubbles will continually form.
Repair using repair kit. If it is a very small pinhole, a dab of the glue
may be sufficient.
Publicité
