DK2 POWER OPC506 Guide De Montage page 7

STEP 4: FEED CHUTE
1. Install the feed chute on the two hinges. To seat the hinge pins for the first time, a rubber mallet
may be used to tap the pins into the hinges. These are tight fitting to reduce vibration noise.
Close the chute and latch it.
2.
3. Plug the safety key shut off wire connectors together.
CONNECT WIRING CONNECTORS
All manuals and user guides at all-guides.com
STEP BY STEP INSTRUCTIONS
ASSEMBLY
v.210818 | 7