Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions - LSR6B / LSSQR6B Commercial LED Rough-In
Cleaning
To Clean Trims:
1.
Press in on white plastic latch to remove upper
reflector and clean lens (Figure 12 & 13).
2.
Gently wipe with soft, clean, dry lint-free cloth to
remove dust.
3.
Wipe with mild detergent solution on a soft, clean
cloth to remove fingerprints and stains.
4.
Rinse with clean water and dry with soft, clean, dry
lint-free cloth.
Electrical Connection
CAUTION
Make certain no bare wires are exposed outside of wire nut
connectors.
1.
Provide electrical service according to the "National
Electrical Code" or your local electrical code to the
cylinder housing assembly. Supply wire insulation must
be rated for at least 90°C (Figure 10).
2.
Connect supply lead wires to cylinder housing lead
wires (line, neutral and ground) in the fixture using the
provided lever nut connectors. Be careful not to leave
any bare conductors outside of the connectors.
3.
Lift the orange tab on the lever nut to disengage the
wire and close to secure the wire in place (Figure 14).
4.
Connect white to white, black to black, and green (from
electrical service) on the supply side to the bare copper
wire in the cylinder housing assembly.
4
IB520017EN
EATON
Installation Instructions
White
Plastic Latch
Figure 12
Figure 13
Lever Closed
Close Lever To
Secure Wire
Figure 14
Upper Reflector
Lens
Lever Open
Open Lever To
Release Or Insert
Wire
Publicité
