Eaton Portfolio LDSQ4B Instructions D'installation

IB520022EN
697916
Installation Instructions – LDSQ4B/LDSQ6B Commercial Recessed
LED Rough-In
Instructions d'installation – Section brute commerciale encastrée à
DEL LDSQ4B/LDSQ6B
Instrucciones de instalación de las luminarias LED empotradas de
uso comercial para áreas ocultas LDSQ4B y LDSQ6B
IMPORTANT: Read carefully before installing fixture.
Retain for future reference.
WARNING
Risk Of Electrical Shock! Disconnect power at fuse or
circuit breaker before installing or servicing.
WARNING
Risk Of Fire! Do not install insulation within 3 inches
(76 mm) of any part of the luminaire fixture or in a
way that may entrap heat.
WARNING
Installation and servicing to be performed only
by qualified personnel. If not qualified, consult an
electrician.
WARNING
Do not energize the LED Engine until the protective
covering has been removed and the lower trim
properly installed. Do not touch the yellow surface of
the LED as it may damage the light engine.
N otee: This fixture should be supported by main runners or
other structure that is capable of supporting fixture
weight of 30 Ibs.
SAFETY: When using electrical equipment, basic safety
precautions should always be followed, including the
following:
1. This unit is for recessed mounting only. Do not use in
hazardous locations nor near gas or electric heaters.
2. Do not use this equipment for other than the intended
use.
3. Install only in accordance with National Electrical Code
and local regulatory agencies' requirements.
Aperture
LDSQ4 4-1/2" x 4-1/2"
LDSQ6 6" x 6"
Brand Logo
reversed out of
black
TM
INS # INS # INS #
Ceiling
Cutout
5-1/4" x 5-1/4"
6-3/4" x 6-3/4"