Télécharger Imprimer la page

LiftMaster ELITE Serie Mode D'emploi page 30

Système d'ouverture de porte de garage pour usage résidentiel et commercial léger. installer en les portes de sectionnelle avec ensembles de torsion seulement
Masquer les pouces Voir aussi pour ELITE Serie:

Publicité

Les langues disponibles

Les langues disponibles

Programming
Your garage door opener has already been programmed at the factory to operate
with your hand-held remote control. The door will open and close when you press
the button shown.
Below are instructions for programming your garage door opener to
operate with additional 895MAX remote controls. To program additional
remote controls, refer to the instructions provided with the remote
control.
To Add or Reprogram a Hand-held Remote Control (Model
895MAX)
1
To enter programming mode, press the Program button until the LEDs on the front of
the remote control turn on.
USING THE SMART
CONTROL PANEL
®
Press and release the Prog <Learn>
2
button on the Smart Control Panel
twice. Within 30 seconds...
Prog <Learn> Button
Press and release the remote control button you want to use...
3
Check to see if the garage door opener
light bulb blinks. If not, wait for the
remote control LED to light solid then
slowly press and release the remote
control button again. Repeat until the
light bulb blinks. DO NOT press the
button after the light bulb blinks.
4
To exit programming mode, press any remote control button except the button that
was just programmed.
Safety Pin or
Paper Clip
OR
USING THE "LEARN" BUTTON
Press and release the Learn button on
2
®
the garage door opener. The Learn LED
will light. Within 30 seconds...
Learn LED
NOTICE: If this Security ✚
opener is operated with a non-rolling
code transmitter, the technical measure
in the receiver of the garage door opener,
Factory Programmed Button
which provides security against code-
theft devices, will be circumvented. The
owner of the copyright in the garage door
opener does not authorize the purchaser or
LEDs
supplier of the non-rolling code transmitter
to circumvent that technical measure.
To Erase All Codes From
Garage Door Memory
To deactivate any unwanted remote, fi rst
erase all codes:
Press and hold the "learn" button on garage
door opener until the learn indicator light
goes out (approximately 6-9 seconds). All
previous codes are now erased. Reprogram
each remote or keyless entry you wish
to use.
30
®
garage door

Publicité

loading

Ce manuel est également adapté pour:

Elite security+ 3800pc