Philips 28PT4404/30 Mode D'emploi page 8

L9 1871.1 GB 1/8 3/10/01
The keys on the TV set
Tips
ß
8
14:03 Page 8
The television set has 4 keys which are located on the front or the top
of the set depending on the model.
The - + (-a+) keys are used to adjust the sound level.
VOLUME
The PROGRAM - + (- P +) keys are used to select the required
programmes.
To access the menus, hold down the
simultaneously.Then use the
and the VOLUME - + keys to make the adjustment.
To exit from the menu, hold down the
for a few seconds.
Poor reception or no picture
The proximity of mountains or high buildings can cause ghost pictures,
echoing or shadows. If this is the case, try tuning the picture using
(p. 3).
TUNE
Do you have the right system (p. 3)?
Check that the aerial plug or euro c o n n e c t o r plug is properly connected.
Check also that your aerial is capable of receiving broadcasts in this
frequency range ( or
UHF
Adjusting the picture
In case of bad reception (fuzzy picture), set the
The picture is in black and white
To read a video cassette, check that it is recorded in the same format as
that of the video recorder (
No sound
If certain programmes have a picture but no sound, this is because you
do not have the correct TV system (see p. 3).
Standby
The set switches automatically to standby if it re c e i ves no signals for a
period of 15 minu t e s .
When it is in standby mode, the set uses energy.To save electricity, we
advise you to switch it off using the on-off button.
Still having problems?
If the set breaks down, never try to repair it yourself. Consult your after-
sales service department instead.
Recycling
The materials used in your set are either reusable or can be recycled.
To minimise environmental waste, specialist companies collect used
appliances and dismantle them after retrieving any materials that can be
used again (ask your dealer for further details).
- and
VOLUME VOLUME
- + keys to select an adjustment
PROGRAM
- and
VOLUME VOLUME
).
VHF
NOISE RED
, or ).
PAL SECAM NTSC
+ keys
+ keys
FINE
to : p. 4.
ON