Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Location 242 Programming the Options and Reader Partitionons (4 segments, FSD)
Segment 1
Segment 2
Segment 3
Segment 4
10
System Options
1
On if reader is enabled for User Card Programming.
2
On if optical tamper is enabled.
3
On if reader buzzer is to follow typical keypad buzzing. (Default is
On.)
4
On if ding-dong chime enabled (dependant on option 3 and chime
being enabled).
5
On if a Request to Exit (RTE) from a scanned card is to be logged
as Code Entry. (Default is On.)
6
On if reader is in CS1700 Legacy Mode (Default is On). Refer to
note below.
7
On if an RTE from a zone or the Egress input is to be logged as
Code Entry.
8
Reserved.
The card reader is defaulted to the Legacy mode. This mode uses the same
scan method as previous CS1700 card readers. However, an alternative scan
method is available by turning off Option 6 in Location 242, Segment 1.
Rather than passing the card (scan) within range of the card reader, the card
can be held at the reader for a specified number of beeps.
Example of Double Scan: Legacy mode – Pass the card by the reader's
sensor, remove it from the sensor area, then pass the card by the reader's
sensor once again. Alternative mode – hold the card at the card reader for a
total of 2 beeps.
1 (Green) Options
On to follow Ready status of system. (Default is On.)
1
2
On to toggle with the Relay Driver activation. (Default is On.)
3
On if inverted.
4
Reserved.
5
Reserved.
6
Reserved.
7
Reserved.
8
Reserved.
2 (Red) Options
On to follow Armed status of system. (Default is On.)
1
2
On to toggle with the Relay Driver activation.
3
On if inverted.
4
Reserved.
5
Reserved.
6
Reserved.
7
Reserved.
8
Reserved.
Reader Partition
On if reader is in Partition 1. (Default is On.)
1
On if reader is in Partition 2. (Default is On.)
2
On if reader is in Partition 3. (Default is On.)
3
On if reader is in Partition 4. (Default is On.)
4
On if reader is in Partition 5. (Default is On.)
5
On if reader is in Partition 6. (Default is On.)
6
On if reader is in Partition 7. (Default is On.)
7
On if reader is in Partition 8. (Default is On.)
8
Proximity Reader Installation Manual
Publicité
Table des Matières
