Installing The Filters - Winix T1 Mode D'emploi

All manuals and user guides at all-guides.com

INSTALLING THE FILTERS

This product comes with all of the required filters. The protective plastic wrap must be
removed from the filters before use.
Operating the unit without removing the plastic wrap may result in product failure.
Unplug and make sure the unit is turned off before installing filters.
On the edge of each filter will show which way should face up.
Remove the Filter Cover
①
Squeeze the the two tabs towards the
middle and pulling it toward yourself.
Remove the bottom filters from the
②
unit, they are protected inside
plastic wrap.
Remove filters from protective
③
plastic wrap.
Operating the unit without removing
filters from plastic wrap may cause
abnormal noise, deformation, or fire as a
result of overheating.
Install the bottom filters.
④
Insert the filters into the
appropriate slots until the
back of the filter touches
the rear of the unit.
Fine Mesh Pre-Filter
Replace the Filter Cover.
⑤
Squeeze the the two tabs towards the
middle and attach it back to the unit.
English
High
TM
Capacity AOC
Carbon Filter
Anti-microbial
PM 2.5 Filter
9
T1