Kohler K-6654 Guide D'installation page 3

All manuals and user guides at all-guides.com
Hanger Bracket
Nut
Rail
Bolt
Rail
Bolt
A
1. Install Using the Undermounter Kit
Thread the bolts into the nuts two turns.
Slide the nuts into the slots in the rails.
Position the bolts through the rail slots where the corners of the
sink will be located.
Slide a hanger bracket onto the end of each rail.
Position the rail assemblies into the cabinet running front-to-back.
Measure the overall width of your sink. This distance represents
the distance "A" between the outside edges of the rails as shown
in the illustration.
Position the hanger brackets according to distance "A" and mark
the screw hole locations onto the cabinet.
Drill 1/8" (3 mm) starter holes at each marked location.
Proceed to the "Install the Sink" section.
Kohler Co. 3 1092948-2-A