Programming The Timer; Set The Timer - GE GXSS20B Manuel Du Propriétaire Et Directives D'installation

Display

Programming the Timer

Set the timer:

When the transformer is plugged into electrical outlet, 12:00AM, SUnday will begin to flash in the time display.
Set the time of day and present day of week as follows:
A. Set the time of day:
Press the TIME/DAY button once and the hour
1
display will begin to flash.
Press the SET/CLEAR button until the present
2
hour of the day shows in the display. Be sure
AM shows for morning hours, or PM for
afternoon and evening hours.
NOTE: Press SET/CLEAR button and quickly
release to move the hour display ahead 1 at
a time to the correct hour. Or, hold the
SET/CLEAR button to move the display ahead
2 hours each second, to the correct hour.
Press the TIME/DAY button once to steady the
3
hour display, and minutes begin to flash.
Repeat Step A.2 to set the correct minutes.
Press the TIME/DAY button again to steady the
4
minute display (day will begin flashing). Fig.
7 shows the timer set at 3:30 PM.
Fig. 7 EXAMPLE: This drawing shows the
present time of day at 3:30 PM,
and the present day on TUesday.
See the Operating section for other
timer controls and features.
B. Set the present day of the week:
Press the SET/CLEAR button to set the present
1
day of the week in the display.
NOTE: Press SET/CLEAR button and quickly
release to move the day display 1 at a time. Or
hold the SET/CLEAR button to move the day
display ahead 2 days each second.
Press the TIME/DAY button again to steady the
2
entire display. Fig. 7 shows the timer set at
TUesday.
No other settings are needed after installing your
water softener. The softener is factory set to
regenerate every Monday, Wednesday and Saturday
(beginning at 2:00 AM). For most families, this gives
enough soft water for their needs. However, if you
want the softener to regenerate at a different time,
or on different days, or to set for the most efficiency,
see About the Water Softener System section.
9