Kapro Prolaser 852G Manuel D'utilisation page 11

Working in Manual mode:
In Manual mode, the 852G's self-leveling mechanism is disabled and
the laser lines can be set at any slope required. The laser beams will
flash every 3 seconds to let you know that you are working without
the self-leveling and the beams may not be leveled.
1. Press the Manual push button mode M. The laser will project
the cross lines.
2. Choose the beams that you want to work with by pushing
the Beam Selector push button H/V.
3. To mark a slope, tilt the laser using to reach the required angle.
4. To turn the manual mode off, press again the Manual
push button M.
5. While in Manual mode sliding the locking switch #1 from
OFF to ON will turn off the Manual mode. The automatic self –
leveling will be activated if the laser level is within the self –
leveling range.
11