DeWalt DC940 Manuel page 30

E N G L I S H
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or
Using an extension cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size
2
is 1 mm ; the maximum length is 30 m.
Assembly and adjustment
● Prior to assembly and adjustment,
always remove the battery pack.
● Always switch off the tool before
inserting or removing the battery pack.
Use only D WALT battery packs and
E
chargers.
Battery pack (fi g. A & B)
Charging the battery pack (fi g. A)
When charging the battery pack for the fi rst time,
or after prolonged storage, it will only accept an
80% charge. After several charge and discharge
cycles, the battery pack will attain full capacity.
Always check the mains prior to charging the
battery pack. If the mains is functioning but the
battery pack does not charge, take your charger
to an authorised D WALT repair agent. Whilst
E
charging, the charger and the battery pack may
become warm to touch. This is a normal condition
and does not indicate a problem.
Do not charge the battery pack at
ambient temperatures < 4 °C or > 40 °C.
Recommended charging temperature:
approx. 24 °C.
● To charge the battery pack (10), insert it into the
charger (12) as shown and plug in the charger.
Be sure that the battery pack is fully seated in
the charger. The red charging indicator (13) will
blink.
● When fi nished charging, the charging indicator
will stop blinking and remain on.
30
All manuals and user guides at all-guides.com
● The battery pack can be removed at any time or
.
Inserting and removing the battery pack
● Insert the battery pack into the grip until it clicks
● To remove the battery pack, press the two
Battery cap (fi g. B)
A protective cap is supplied to cover the contacts
of a detached battery pack. Without the protective
cap in place, loose metal objects could short circuit
the contacts, causing a fi re hazard and damaging
the battery pack.
● Take off the protective cap (14) before placing
● Place the protective cap over the contacts
Automatic refresh
● To refresh your battery pack, place the battery
● When the charge cycle has completed, the
The battery pack is now fully charged.
left in the connected charger for a longer period
of time (with a maximum of 14 days).
in place.
release buttons (11) simultaneously and pull the
pack out of the grip.
the battery pack (10) in the charger or tool.
immediately after removing the battery pack
from the charger or tool.
Make sure the protective cap is in place
before storing or carrying a detached
battery pack.
The automatic refresh mode will
equalize or balance the individual
cells in the battery pack at its peak
capacity. Battery packs should be
refreshed overnight after every 10th
charge/discharge cycle or whenever
the pack no longer delivers the same
amount of work.
in the charger as usual. The red light will blink
continuously indicating that the charge cycle
has started.
light will stay on continuously and will no longer
blink. The pack is fully charged and can be
used at this time.